La coaxialitat del forat de sortida del broquet i el raig làser és un dels factors importants que afecten la qualitat del tall. Si el broquet i el làser no són coaxials, afectarà la inconsistència de la superfície de tall. En casos greus, el làser farà que el broquet s'escalfi i es cremi.
Preparació
Passos d'atenuació
Si l'enfocament del capçal làser no està configurat en 0 al programari operatiu, canvieu la potència de ràfega làser al 100%
2. Replacement of 1.5mm diameter nozzle
3. Attach to the nozzle plane with scotch tape
4. Click the laser shot button and release it immediately
5. Remove the tape and check the imprint, be careful not to turn the direction, there is a circle with the size of the aperture on the imprint, observe if the light spot is in the exact center of the nozzle circle
6. If the light spot is not in the center of the nozzle circle, you need to adjust the position of the light spot by rotating the left and right screws with the Allen wrench until the light spot moves to the center of the circle
7. Adjust it according to the corresponding position of the light spot and the circle
8. After repeated testing and adjustment, the coaxiality adjustment operation is completed until the light spot moves to the center of the circle.
